Sign in to confirm you’re not a bot
This helps protect our community. Learn more

mounted the outside units on wall mounts

2:49

get the unit 12 inches away from the wall

3:04

ran the power through an ac disconnect box

3:58

begin mounting the indoor unit the mounting plate

4:49

bend the pipe a full 180

6:20

wrap the drain hose and the signal cable

6:41

drill the two-and-a-half inch inside hole

6:51

drill the outside hole using the pilot hole

7:23

connect the signal cable

8:23

connect the drain pipe

9:15

connect the refrigerant piping

9:20

connecting the refrigerant pipes to the unit

10:10

mounting the indoor unit to the wall

10:17

mount the indoor unit to the wall

10:33

tighten the pipe fittings in a very small space

10:46

take the end caps off of refrigerant

10:53

applied the leak guard to the flare

11:04

connect the refrigerant hose on the bottom on the outside unit

11:55

release the refrigerant into the indoor unit

12:42

connect the blue low side hose of the manifold

13:14

connect the yellow middle hose from the manifold gauge

13:48

run the vacuum pump for at least 15 minutes

14:07

take a section of the drain hose from the indoor unit

15:57

tighten the valve caps on all three valves

16:32

disconnect the service hose

16:46

jammed some of that supplied putty into the end of the pipe hole

18:03